The JJ-3 insulation piercing clamp has a main line cross-section of 16-95mm, a branch cross-section of 1.5-10mm, an applicable voltage of 1KV, and a nominal current carrying capacity of 138. It has the characteristics of long service life, high conductivity, and firm wiring.Features: 1. Simple installation: puncture structure, no need to strip the wire, torque nut, constant puncture pressure.2. Thickened shell: Nylon material is used to ensure that it can bear enough pressure.3.
Связаться сейчас
PVC insulation piercing connector It is suitable for the branching and splicing of overhead insulated wires of 1kV and below. Features:Fully insulated housingStructure sealed, waterproof, anti-corrosion, long lifePuncture structure, torque bolt, ensure puncture pressureDifferent diameter and different wire connection, strong applicability.Model No.Suitable conductor range sqmmMain dimensionsqmmNormal current(A)Bolt noMain lineSub lineABHJBC1/7010-7015-10412355551JBC1/9516-951.5-10412655551JBC-116-12016-1206049802991JBC-250-24050-2407484.51164762
Связаться сейчас
The JJC-2 piercing clamp is equipped with a tightening torque nut. The screws are treated with corrosion resistance. The torque nut makes installation easier, safer and faster. Its constant piercing pressure can ensure the cable connection to achieve the best electrical effect. The puncture has a waterproof function, and can withstand a voltage of 6kv in water without breakdown.
Связаться сейчас
The JJC series of low-voltage cable piercing clamps use excellent insulation materials and sufficient materials, which greatly improves the stability of the product and has a long service life. The product models are complete in variety, stable in size and easy to match. It is used for the branch connection of insulated cables in building power distribution systems, the connection of low-voltage overhead insulated cables, the branch connection of low-voltage insulated incoming cables, and the street lamp power distribution system. Features:1. Main branch: 1.5-25sqmm2.
Связаться сейчас
The JJ-3 insulation piercing clamp has a main line cross-section of 16-95mm, a branch cross-section of 1.5-10mm, an applicable voltage of 1KV, and a nominal current carrying capacity of 138. It has the characteristics of long service life, high conductivity, and firm wiring. Features:1. Simple installation: puncture structure, no need to strip the wire, torque nut, constant puncture pressure. 2. Thickened shell: Nylon material is used to ensure that it can bear enough pressure.3.
Связаться сейчас
The JJC-2 piercing clamp is equipped with a tightening torque nut. The screws are treated with corrosion resistance. The torque nut makes installation easier, safer and faster. Its constant piercing pressure can ensure the cable connection to achieve the best electrical effect. The puncture has a waterproof function, and can withstand a voltage of 6kv in water without breakdown.
Связаться сейчас
The JJC series of low-voltage cable piercing clamps use excellent insulation materials and sufficient materials, which greatly improves the stability of the product and has a long service life. The product models are complete in variety, stable in size and easy to match.
Связаться сейчас
Nylon cable ties are made of UL-approved nylon-66 (Nylon 66) by injection molding, with a fire rating of 94V-2. They have good acid resistance, corrosion resistance, insulation, resistance to aging, and strong endurance. The operating temperature is -20°C to +80°C (normal nylon 66). Nylon cable ties have high tensile strength, impact resistance, and strong acid and alkali resistance.
Связаться сейчас
Applications 1.Tensile clamps for OPGW optical cables are mainly used to connect optical cables with a breaking strength of 160kN and below to tensile poles, corner poles and terminal poles. The complete set of OPGW optical cable strain clamp includes outer pre-twisted wires, inner pre-twisted wires, supporting connectors and grounding wires.
Связаться сейчас
The pole hoop has various dimension of 50mm 65mm 75mm 80mm 100mm 130mm 150mm 200mm 250mm 300mm 350mm 400mm 500mm. Semi-circular cable hoop used in high-altitude suspension, hardware fasteners, the product is waterproof and rust-proof. It is used in complex and harsh environments, and the effect is good. Features: 1.
Связаться сейчас
PAL1000 aluminum alloy optical cable insulation strain clamp is a product suitable for overhead insulated conductors. The product is used for cable pull, aluminum alloy body material, PA66 insulation core, stainless steel wire rope, and the product process is die-casting. The high-quality aluminum alloy material has strong corrosion resistance and is not easy to rust and age. The appearance is neat and tidy, and the unique design can well protect the cable.Features:1. Material: high strength aluminum alloy.
Связаться сейчас
Tension insulators are used for transmission and distribution lines and communication lines, broadcast line terminals, corners or large-span poles, The balance pole is subjected to tensile stress. When in use, the wire and the pull wire pass through the hole and slot, and the tension wire is used for insulation and connection.Features:1. Material: high strength carbon steel2. Application: for stay rod assembly3. Dimension: M16×1830mm4. Finish: hot dip galvanized
Связаться сейчас
Insulation strain clamp PAL2000 is used for overhead ABC cable, aluminum alloy main body, nylon PA66 insulation core, stainless steel wire rope. The wedge-shaped insulated aluminum alloy tension clamp produced by our company has a variety of specifications. PAL2000 is used for cables with a diameter of 70sqmm to 150sqmm and a tensile load of 15KN. The length of the wire rope can be customized, and the batch quantity can be printed on the product according to customer needs . Features:1. Material: high strength aluminum alloy.
Связаться сейчас
The stainless steel hoop produced by our company is usually made of C201, 304 material ,with good toughness, fire-proof, waterproof and rust-proof, abrasion resistance, corrosion resistance, and durability.The slitting is complete, polished, trimmed to remove burrs, smooth and not hurting hands, safe and reliable.Features:1. Anti-corrosion, anti-oxidation,2. Long service life, high tensile strength,3. Flexible and quick installation, etc.4. Uses: Traffic signs, advertising signs, cables, surveillance and other different areas. TECHNICAL COMPOSITION (%)CSiMnPSNiCrC
Связаться сейчас
Dead end clamp is made of plastic body with very high mechanical and climatic resistance. A stainless steel flexible cord equipped with movable insulating saddle and two sleeves compressed on the ends to prevent detachment from the clamp body.An inner sheath consisting of two insulating plastic wedges for clamping of the neutral carrier without damaging the cable insulation.
Связаться сейчас
Features: 1.High mechanical strength. 2.Aluminum alloy material, rust proof and waterproof. 3.Spiral design anti corona. Anti-corona ring for ADSS is made of Al. Alloy. 1.Select the required model according to the diameter of the optical cable. 2.Each set of strain clamp is equipped with an anti-corona ring.The ADSS optical cable erected on the same pole with the high-voltage overhead transmission line is prone to electrical corrosion at the outlet of the fittings.
Связаться сейчас
The tension clamp NLL-1 is suitable for the overhead lines of 10kv and below. It is used to fix the aluminum stranded wire or the steel core aluminum stranded wire on the tension rod. When used for the overhead insulated aluminum wire, it is used in conjunction with the insulating cover to provide insulation protection. The wedge-shaped strain clamp has the advantages of very small hysteresis loss, light weight, convenient installation, etc., which meets the requirements of energy saving and consumption reduction in the transformation of the national grid.
Связаться сейчас
ADSS optical fiber cable insulation wedge clamp is a kind of ADSS optical cable clamp. Mainly used for optical cables with 6-9mm cable diameter. The main body material is PA66, stainless steel wire rope, injection molding process, widely used in communication engineering, etc. Large quantities are exported to South America, Southeast Asia and other countries and regions.Features:Dimension: 173×65×40mmUnit weight:190gCarton size: 550×410×250mmQuantity per carton : 100 piecesMaterial: Nylon and stainless steelCable diameter: 6-9mm Installation image:
Связаться сейчас
Down-lead clamps for rubber towers are used to fix the up and down or up of the optical cable on the tower so that it will not shake and avoid the optical cable from wearing. Features: 1.Wide range of application: It is suitable for skeleton type, layer stranded type, beam tube type armored and non-armored fiber optic cables, and is flexible in use. 2.
Связаться сейчас
The transformer bracing cross arm is the cross of dimension of 550x50x50x6mm。The cross arm is hot dipped galvanized.All steel members and other parts of fabricated material as delivered is free of warps, local deformation.Bending of flat strap is carried out cold.About surface treatment:All galvanizing is carried out by the hot dip process. The zinc coating is smooth, continuous and uniform. It is free from acid spot and shall not scale, blister or be removable by handling or packing.
Связаться сейчас
ADSS optical cable suspension clamp components: 1.Aluminum clamp:made of corrosion-resistant aluminum alloy pressure casting, the aluminum alloy has stable chemical properties, good atmospheric corrosion resistance and good mechanical properties. 2.Rubber clamp:Composed of high-quality rubber and center reinforcement, it has the properties of ozone resistance, chemical resistance, weather resistance, high and low temperature performance, high strength and elasticity, and small compression deformation. 3.Bolts, flat washers, spring washers, nuts, closed pins, U-shaped hanging rin
Связаться сейчас
Details and characteristics of strain clamps: 1.U shackle: hot-dip galvanized cast steel U-shaped hanging ring, which is used to connect with the pole tower fastener. 2.Insert ring: Hot-dip galvanized precision cast steel insert ring, which is embedded in the bending head of the U-shaped hanging ring of the tension clamp, which can protect the tension clamp and connect with the extension rod. 3.PD hanging plate: The hot-dip galvanized precision cast steel PD hanging plate is used to connect the embedded ring and the U-shaped hanging ring, and avoid the optical cable at the exit
Связаться сейчас
Grade 8.8 black finish high strength nuts are made of carbon steel, with high hardness and good wear resistance; surface treatment is black, smooth and complete, the surface is smooth without burrs, and the pattern is evenly distributed; the thread is complete, the turnbuckle is deep, and the force is uniform and not easy to be silky , It is not easy to slip and lock during rotation.
Связаться сейчас
ADSS spiral helical dead end consists of an anchor shackle, thimble clevis and preformed guy grip of suitable length, which used for supporting ADSS fiber optic cable in tension at cable sections, acute turnings or at the terminal pole. -Design for quick and easy installation-Minimizing time consuming civil works -Provide a future proof aerial network-Temperature: -10°C up to +70°CSn Model No. Suitable for ADSS cable range(mm) 300M spanANZ 030/0940 8.6-9.4ANZ 030/1010 9.5-10.1ANZ 030/1070 10.2-10.7ANZ 030/1140 10.8-11.4ANZ 030/1220 11.5-12.2ANZ
Связаться сейчас